Table of Contents
Advertisement
RIP
RIP, Router Information Protocol, is a simple Interior Gateway Protocol (IGP). RIP supports RIP-1 ,
RIP-2 and both.
Interface: the interface the rule applies to.
Version: select the RIP version, RIP-1, RIP-2 and both.
Operation: RIP has two operation mode.
Passive: only receive the routing information broadcasted by other routers and modifies its
routing table according to the received information.
Active: working in this mode, the router sends and receives RIP routing information and
modifies routing table according to the received information.
Enable: check the checkbox to enable RIP rule for the interface.
Note:
RIP can't be configured on the WAN interface which has NAT enabled (such as PPPoE).
Click Apply to apply your settings.
212
Advertisement
Table of Contents
