Your Appliance - Baumatic BHI100 Instruction Manual

setting.
Fan noise coming
from the induction
hob.
The power light (2)
turns on but the pans
do not become hot.
The induction hob or
a cooking zone has
turned itself off
unexpectedly.
IMPORTANT: If

your appliance

appears not to
be operating
correctly, then
you should
disconnect it
from your
mains supply and then
contact the Baumatic
Customer Care Department
on telephone number (0118)
933 6911.
A cooling fan built into your
induction hob has come on to
prevent the electronics from
overheating. It may continue
to run even after you've
turned the induction hob off.
The induction hob cannot
detect the pan because it is
not suitable for induction
cooking.
The induction hob cannot
detect the pan because it is
too small for the cooking zone
or not properly centred on it.
The ambient temperature
detected is too high.
The air entry or air vent slot is
blocked.
The maximum working time
has been reached.
18
level.
This is normal and needs no
action. Do not switch the
power to the induction hob
off at the wall while the fan
is running.
Use cookware suitable for
induction cooking. See the
section on cookware in this
manual.
Centre the pan and make
sure that its base matches
the size of the cooking zone.
Wait for the temperature to
lower before turning the hob
on again.
Check the air entry and air
vent slots for blockages.
If the error keeps occurring,
please call the Customer
Care Department.
DO NOT ATTEMPT TO REPAIR
THE APPLIANCE YOURSELF.
Please note that if an engineer
is asked to attend whilst the
product is under guarantee and
finds that the problem is not the
result of an appliance fault, then
you may be liable for the cost of
the call out charge.
Please refer to the conditions of
guarantee that appear on the
warranty card that you receive
with the appliance.