Info Menu - Bacharach IEQ Chek Operation Manual


IEQ Chek Operation Manual
NEXT:
TEMP:
HUMIDITY: This menu item puts an asterisk in front of the humidity sensor
CO:
CO2:
NOTE: Other sensors may be indicated here. Only installed sensors will be on
this list. Pressing the MENU button at any of the sensors listed puts an asterisk in
front of the gas name, indicating it has been selected to activate the audible
alarm if real-time gas values are above preset alarm levels.
SET ALARM: This menu item allows the user to enter an alarm set point for any
installed sensor. The user must first enter the four digit security code. Use the UP
ARROW or DOWN ARROW and MENU buttons to enter the numbers of the security
code. When finished push the MENU button and the LCD will accept the code if it was
entered correctly and display the list of installed sensors.
Using the ARROW DOWN button, scroll down to the first sensor that you wish you
enter an alarm set point for then push the MENU button. The display will indicate
ENTER ALARM VALUE. Use the ARROW UP and/or ARROW DOWN buttons to
enter the desired numbers then press the MENU button to accept the new value. The
LCD will indicate NEW ALARM VALUE ENTERED and go back to the list of installed
sensors.
Once again, use the ARROW DOWN button to scroll down to the next sensor that is
to have an alarm set point and repeat the procedure. Each time the MENU button is
pressed to accept the new alarm set point, the LCD will go back to the list of sensors.
When finished, press the MENU button at PREVIOUS and the alarm menu will be
displayed.

5.5. Info Menu

This menu item provides the user with information about the instrument. The choices
are for the instrument and installed sensors with serial numbers (does not include
temperature and RH sensors as they do not have serial numbers). Example of
choices are shown below.
MONITOR: LCD indicates instrument serial number and date of manufacture
CO:
CO2:
18
Select next after you have highlighted only the sensors you want to
have alarm set points for. Press the MENU button at this menu item
and the LCD indicates ALARM SET UP HAS BEEN SAVED. The
LCD then goes back to the alarm menu.
This menu item puts an asterisk in front of the temperature sensor
(installed) indicating it has been selected to have an alarm set point.
(installed) indicating it has been selected to have an alarm set point.
This menu item puts an asterisk in front of the CO sensor (installed)
indicating it has been selected to have an alarm set point.
This menu item puts an asterisk in front of the CO
(installed) indicating it has been selected to have an alarm set point.
LCD indicates sensor serial number, sensor date code, calibration
information, and span and zero dates.
LCD indicates sensor serial number, sensor date code, calibration
information, and span and zero dates.
sensor
2
1509-9001 Rev 1