Adjustment Button For Printhead Pressure - Avery Dennison ALX 92x Operating Manual

06/06 Rev. 3.05-01
Adjustment button for
printhead pressure
The material width and / or material
thickness influence the pressure applied by
the thermal transfer printhead on the print
roller.
There are three possible settings for
pressure [23]:
I Setting for thin / narrow material
II Setting for material of medium width /
thickness
III Setting for thick / broad material
Setting
The red adjustment knob [22A] [23] is
located above the ribbon roller in the front
plate and can be adjusted with a coin or
large screwdriver.
To set medium pressure, turn the arrow
[23A] to position „II" until it slots gently into
place.
To set a higher pressure, turn the arrow to
position „III" until it slots gently into place.
CAUTION! - Failure to set for the
correct pressure causes the printhead
to wear down more quickly and leads
thus to a shorter service life.
Always select the lightest possible
pressure necessary to produce an
acceptable print result.
Excessive pressure can lead to the
premature wearout of the printhead.
Factory settings
Setting „I", for thin / narrow material
OPERATING MANUAL
ALX 92x
A
[22] A Adjustment knob for the printhead pressure
[23] A Adjustment knob for the printhead pressure
Setup
A
15