Preparation For Operation; Operation In The Dark Condition - ATN VOYAGER 3 Operator's Manual

cONTROlS
Sensor of Highlight
protective System
proximity Sensor
Indicator in Fov

2.2.2. PREPaRaTION FOR OPERaTION

to check the device in the daytime conditions or in the light room:
1. make sure the battery is installed as indicated on the bi-ocular
body.
2. make sure the lens cap is attached to the front lens and protec-
tive System sensor cap covers the sensor.
3. turn on the device by pressing on-oFF button. after this you
can start observing scene through the oculars. the greenish-
lit screen of the image tube means that the device is working
normally.
4. Direct the bi-ocular at an object located 15-25 yards/m from
you and obtain a sharp image by turning eyepieces (see sec-
tion 2.2.3).
5. turn off the device by pressing on-oFF button again.
cauTION
Never use your night vision device in daylight areas without
the lens cover on! Never direct the lens to the bright light!
2.2.3. OPERaTIONS IN THE DaRK cONDITIONS
cauTION
bright sources such as light of fire, headlights, searchlights,
2-6
The automatic Highlight Protective System ana-
lyzes light exposure with the sensor.
Identifies the user's intention to look through the
bi-ocular by turning the unit automatically on.
When proximity sensor is on, the indicator in
the Fov will lights red.
If the level of light exposure exceeds allowable
the indicator will lights green.
When the battery is low the red indicator in the
Fov starts blinking.
FuNcTION