Table of Contents
Advertisement
Change the IP Address by Hyper Terminal
The default IP address of IP-08 is 192.168.1.100. Your network may have a different IP address
range such as 192.168.10.xx. In this situation, you can not access to IP-08 by putty and browser if
you do not change the IP-08 IP address. So you have to change the IP address for IP-08 by Hyper
Terminal to make it in the same network segment as your LAN.
After you have accessed to IP-08 by Hyper Terminal, please use the following command to
change the IP address for IP-08.
root:~> ifconfig eth0 192.168.1.151(the IP address you want to set for IP-08)
By this way, the IP address you set for IP-08 is temporary, it will recover to the original default IP
address after rebooting. If you want to give a static and permanent IP address for IP-08, you can
try to set it in web GUI, for detail steps please refer to chapter 3.
www.atcom.cn
11
Advertisement
Table of Contents
Need help?
Do you have a question about the IPPBX IP08 and is the answer not in the manual?
Questions and answers