Setting Up The Hardware Environment - Planet GRT-101 User Manual

PLANET Technology Corp.
Server
HUB/Switch
Power
Figure 2-4 Connection with Switch or HUB

2.4 Setting up the hardware environment

Step 1: Connect the power adapter to the port labeled DC-IN on the rear
panel of the product.
Step 2: Connect the Ethernet cable.
If GRT is directly connected to PC, the Ethernet cable has to be used
cross over one (refer to figure 2-3). If the product is connected to hub
or switch, be sure that the hub or switch supporting auto-sensing or
not. If yes, both cross over and none cross over Ethernet cable are
suitable. If not, only none cross over Ethernet cable could be used
(refer to figure 2-4).
Step 3: Connect the phone cable to the product. Connect the other side of
phone cable to wall jack.
Step 4: Connect male end of RS-232 cable to the product and female end to
any free COM port in PC.
Step 5: Connect the power adapter by plugging power supply.
File Server
Workstation
Non-cross Over Ethernet
PC
DB-9
- - 6
GRT-101 User's Manual
NB
Mobile
Device
Wireless LAN
Wall Jack