Dns Proxy; Wan And Atm Virtual Connection - Planet GRT-101 User Manual

G.shdsl bridge/router
Hide thumbs Also See for GRT-101:
Table of Contents

Advertisement

PLANET Technology Corp.
GRT-101 User's Manual
towards a valid host that provides DNS lookup service. These parameters
should be configured correctly, or computers on the LAN may not access
Internet.
Note: If the DNS proxy has been configured properly, the "name_server1" field in the above DHCP configuration
should be set with the LAN IP address of GRT-101.
To save your changes, type:
admin# write

3.11.5 DNS proxy

DNS is the naming system for IP based networks and the naming service that
is used to locate computers on the Internet. A DNS proxy receives DNS re-
quest from computers on the LAN, translates them into the encoding on DNS
protocol, and forwards to the real DNS server. To enable the DNS proxy,
please correctly set up the DNS proxy so that it can point towards real DNS
servers on the Internet. The following example shows you how to setup the IP
addresses of real DNS servers:
admin# setup dns_proxy 168.95.1.1 168.95.192.1 140.92.61.55
Note: For PPP connections, GRT-101 will get DNS server IPs from ISP and assign them into DNS proxy automatically
if they have been pre-configured by the local ISP.
The maximum number of DNS servers is limited to 3. To save your changes,
enter:
admin# write

3.12 WAN and ATM Virtual Connection

GRT-101 has two types of WAN ports: physical WAN port (SHDSL) and logical
WAN ports (WAN 1~8). The physical WAN port connects GRT-101 to the WAN.
The logical WAN port or ports allow you to create virtual WAN connections for
plural destinations. When configuring the physical WAN port, you can change
the SHDSL physical layer protocol setting. To configure logical WAN ports, you
must provision ATM virtual connections for each logical connection. The in-
structions for each are shown below.
- -
51

Advertisement

Table of Contents
loading

Table of Contents