Adjusting The Speaker Output Levels - Pioneer DVH-P6050UB Operational Manual

Section
03 Available accessories
2 Push MULTI-CONTROL left or right to
select the speaker to be adjusted.
FRONT (front speakers)—CENTER (center
speaker)—REAR (rear speakers)—SUB.W
(subwoofer)
3 Push MULTI-CONTROL up or down to
select cross-over frequency for the selected
speaker.
63HZ—80HZ—100HZ—125HZ—160HZ—
200HZ
Note
Selecting a cross-over frequency is to set a cross-
over frequency of the subwoofer's L.P .F. (low-pass
filter) and that of the SMALL speaker H.P.F. (high-
pass filter). The cross-over frequency setting has
no effect if the subwoofer is set to OFF and other
speakers are set to LARGE or OFF.
Adjusting the speaker output
levels
Speaker level can be adjusted finely by listen-
ing to an audio output. First, use test tone to
adjust the approximate speaker level, and then
use this function to adjust finely.
1 Use MULTI-CONTROL to select
FRONT-LEFT.
Refer to Introduction of DSP adjustments on
page 64.
2 Push MULTI-CONTROL left or right to
select the speaker to be adjusted.
FRONT-LEFT (front speaker left)—CENTER
(center speaker)—FRONT-RIGHT (front speak-
er right)—REAR-RIGHT (rear speaker right)—
REAR-LEFT (rear speaker left)—SUB WOOFER
(subwoofer)
# You cannot select speakers whose size is set
at OFF. (Refer to Setting the speaker setting on
page 70.)
72
En
3 Push MULTI-CONTROL up or down to
adjust the speaker output level.
+10 to –10 is displayed as the level is in-
creased or decreased.
Note
To adjust the speaker output levels in this mode is
the same as making the speaker output levels at
TEST TONE. Both provide the same results.