Switching The Ever Scroll; Setting The Tv Signal; Correcting Distorted Sound; Resetting The Audio Functions - Pioneer DVH-P6050UB Operational Manual

Operating this unit
2 Press MULTI-CONTROL to switch the
rear output setting.
Pressing MULTI-CONTROL will switch be-
tween FULL (full-range speaker) and SUB W
(subwoofer) and that status will be displayed.
# When no subwoofer is connected to the rear
output, select FULL (full-range speaker).
# When a subwoofer is connected to the rear
output, select SUB W (subwoofer).
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
40).
! If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.

Switching the ever scroll

When Ever Scroll is set to ON, recorded text in-
formation scrolls continuously in the display.
Set to OFF if you prefer the information to
scroll just once.
1 Use MULTI-CONTROL to select
EVERSCROLL.
Refer to Adjusting initial settings on page 48.
2 Press MULTI-CONTROL to turn the ever
scroll on.
# To turn the Ever Scroll off, press
MULTI-CONTROL again.

Setting the TV signal

When this unit is connected to a TV tuner, you
need to adjust the TV signal suitable to your
country TV signal setting.
! About your country TV signal, consult with
your nearest Pioneer dealer.
1 Use MULTI-CONTROL to select
TV SIGNAL.
Refer to Adjusting initial settings on page 48.
2 Press MULTI-CONTROL to select an ap-
propriate TV signal.
PAL—SECAM

Correcting distorted sound

Only when the multi-channel processor (e.g.,
DEQ-P7650) is connected to this unit, you can
operate this function.
You can minimize distortion that may be
caused by the equalizer curve settings.
Setting an equalizer level high can cause dis-
tortion. If high sound is crippled or distorted,
try switching to LOW. Normally, leave the set-
ting at HIGH to ensure quality sound.
1 Use MULTI-CONTROL to select D.ATT.
Refer to Adjusting initial settings on page 48.
2 Press MULTI-CONTROL to switch the di-
gital attenuator setting.
! HIGH – High quality sound
! LOW – Minimize distortion sound

Resetting the audio functions

Only when the multi-channel processor (e.g.,
DEQ-P7650) is connected to this unit, you can
operate this function.
You can reset audio functions other than the
following settings.
! Volume setting (refer to Adjusting the vo-
lume on page 18)
! Listening position setting (refer to Using
the position selector on page 65)
! Fader/balance setting (refer to Using bal-
ance adjustment on page 65)
Section
02
51
En