Selecting A Cross-Over Frequency - Pioneer DVH-P6050UB Operational Manual

Available accessories
! It is imperative that non-installed speakers
be set to OFF.
! Set the front or rear speaker to LARGE if
the speaker is capable of reproducing bass
content, or if no subwoofer is installed.
1 Use MULTI-CONTROL to select FRONT.
Refer to Introduction of DSP adjustments on
page 64.
2 Push MULTI-CONTROL left or right to
select the speaker to be adjusted.
FRONT (front speakers)—CENTER (center
speaker)—REAR (rear speakers)—
SUB WOOFER (subwoofer)—PHASE (subwoo-
fer setting)
# You can switch to PHASE only when the sub-
woofer has been set to ON.
3 Push MULTI-CONTROL up or down to
select the correct size for the selected
speaker.
SMALL (small)—LARGE (large)—OFF (off)
# You cannot select OFF, when FRONT (front
speakers) have been selected.
# You can select ON or OFF, when
SUB WOOFER (subwoofer) has been selected.
# You can switch REVERSE (reverse phase) or
NORMAL (normal phase), when PHASE (subwoo-
fer setting) has been selected.
Correcting the subwoofer's phase
If trying to boost the bass output of the sub-
woofer doesn't do much or rather makes you
feel that the bass gets more murky, this may
indicate that the subwoofer's output and bass
content you hear over other speakers cancel
each other out. To remove this problem, try
changing the phase setting for the subwoofer.
1 Use MULTI-CONTROL to select FRONT.
Refer to Introduction of DSP adjustments on
page 64.
2 Push MULTI-CONTROL left or right to
select SUB WOOFER.
FRONT (front speakers)—CENTER (center
speaker)—REAR (rear speakers)—
SUB WOOFER (subwoofer)—PHASE (subwoo-
fer setting)
3 Push MULTI-CONTROL up to turn the
subwoofer output on.
4 Push MULTI-CONTROL right to select
PHASE (subwoofer setting).
5 Push MULTI-CONTROL up or down to
select the phase of subwoofer output.
Push MULTI-CONTROL up to select NORMAL
(normal phase). Push MULTI-CONTROL down
to select REVERSE (reverse phase).
Note
When playing a 2-channel mono source with Pro
Logic II turned on, there may be occasions when
the following will occur:
! No audio is outputted if the center speaker
setting is SMALL or LARGE and no center
speaker is installed.
! Audio is heard only over the center speaker if
installed and the center speaker setting is
SMALL or LARGE.

Selecting a cross-over frequency

You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to SMALL, you can select a
frequency, under which sounds are repro-
duced through a LARGE speaker or subwoo-
fer.
1 Use MULTI-CONTROL to select HPF.
Refer to Introduction of DSP adjustments on
page 64.
Section
03
71
En