Adjusting The Speaker Output Levels - Pioneer AVH-P6050DVD Operation Manual

Section
17 Digital Signal Processor
1 Touch SPEAKER SETTING on the DSP
function menu.
2 Touch c or d to select the speaker to
be adjusted.
Each time you touch c or d selects the speak-
er in the following order:
FRONT (front speakers)—CENTER (center
speaker)—REAR (rear speakers)—
SUB WOOFER (subwoofer)—PHASE (subwoo-
fer setting)
# You can switch to PHASE only when the sub-
woofer has been set to ON.
3 Touch c or d to select the correct size
for the selected speaker.
Each time you touch c or d selects the size in
the following order:
Speaker
FRONT
CENTER
REAR
SUB WOOFER
PHASE
Correcting the subwoofer's phase
If trying to boost the bass output of the sub-
woofer doesn't do much or rather makes you
feel that the bass gets more murky, this may
indicate that the subwoofer's output and bass
content you hear over other speakers cancel
each other out. To remove this problem, try
changing the phase setting for the subwoofer.
1 Touch SPEAKER SETTING on the DSP
function menu.
2 Touch c or d to select SUB WOOFER.
Each time you touch c or d selects the speak-
er in the following order:
78
En
Setting
SMALL—LARGE
OFF—SMALL—LARGE
OFF—SMALL—LARGE
ON—OFF
REVERSE—NORMAL
FRONT (front speakers)—CENTER (center
speaker)—REAR (rear speakers)—
SUB WOOFER (subwoofer)—PHASE (subwoo-
fer setting)
3 Touch c to turn subwoofer output on.
# To turn subwoofer output off, touch d.
4 Touch d to select PHASE and then
touch c or d to select the phase of sub-
woofer output.
Touch d to select NORMAL (normal phase).
Touch c to select REVERSE (reverse phase).
Note
When playing a 2-channel mono source with Pro
Logic turned on, there may be occasions when
the following will occur:
! No audio is outputted if the center speaker
setting is SMALL or LARGE and no center
speaker is installed.
! Audio is heard only over the center speaker if
installed and the center speaker setting is
SMALL or LARGE.
Adjusting the speaker
output levels
Speaker level can be adjusted finely by listen-
ing to an audio output. First, use test tone to
adjust the approximate speaker level, and then
use this function to adjust finely.
1 Touch SPEAKER LEVEL on the DSP func-
tion menu.
2 Touch c or d to select the speaker to
be adjusted.
Each time you touch c or d selects the speak-
er in the following order: