Adjusting Loudness; Using Subwoofer Output - Pioneer DVH-P6050UB Operational Manual

Section
02 Operating this unit
+6 to –6 is displayed as the level is increased
or decreased.
# You can then select another band and adjust
the level.
Fine-adjusting equalizer curve
You can adjust the center frequency and the Q
factor (curve characteristics) of each currently
selected curve band (EQ-LOW/EQ-MID/
EQ-HI).
! If you make adjustments, CUSTOM curve
is updated.
Level (dB)
Center frequency
1 Use MULTI-CONTROL to select the
equalizer band to adjust.
Refer to Adjusting equalizer curves on the pre-
vious page.
2 Use MULTI-CONTROL to select EQ-LOW.
Frequency and the Q factor (e.g.,
EQ-LOW 80HZ Q1W) appears in the display.
Refer to Introduction of audio adjustments on
page 38.
3 Push MULTI-CONTROL left or right to
select the desired frequency.
Each time MULTI-CONTROL is pushed left or
right, frequencies are selected in the following
order:
Low: 40HZ—80HZ—100HZ—160HZ
Mid: 200HZ—500HZ—1KHZ—2KHZ
High: 3KHZ—8KHZ—10kHZ—12KHZ
40
En
Q=2W
Q=2N
Frequency (Hz)
4 Push MULTI-CONTROL up or down to
select the desired Q factor.
Each time MULTI-CONTROL is pushed up or
down, Q factor is selected in the following
order:
2W—1W—1N—2N

Adjusting loudness

Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Use MULTI-CONTROL to select
LOUDNESS.
Refer to Introduction of audio adjustments on
page 38.
2 Press MULTI-CONTROL to turn loudness
on.
Loudness level (e.g., MID) appears in the dis-
play.
# To turn loudness off, press MULTI-CONTROL
again.
3 Push MULTI-CONTROL left or right to
select a desired level.
Each time MULTI-CONTROL is pushed left or
right, level is selected in the following order:
LOW (low)—MID (mid)—HIGH (high)

Using subwoofer output

This unit is equipped with a subwoofer output
which can be turned on or off.
Also, phase can be selected between normal
and reverse.
1 Press SW to select SUB W1.
Press SW repeatedly to switch between the
subwoofer setting modes in the following
order.
SUB W1 (subwoofer on/off setting) setting
mode—SUB W2 (subwoofer setting) setting
mode