Setting The Rear Output And Subwoofer Controller; Switching The Ever Scroll; Activating The Btaudio Source - Pioneer DEH-P3000IB Operation Manual

Section
D (
Initial Settings
Setting the rear output and
subwoofer controller
This unit's rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (REAR SP:FULL/PREOUT:REAR)
or subwoofer (REAR SP:SUB
WI
PREOUT:SUB W) connection. If you switch the
rear output setting to REAR SP:SUB W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (REAR SP:FULL). When rear out-
put is connected to full range speakers (when
REAR SP:FULL is selected), you can connect
the RCA subwoofer output to a subwoofer. In
this case, you can select whether to use the
subwoofer controller's (low pass filter, phase)
built-in PREOUT:SUB W orthe auxiliary
PREOUT:REAR.
1 Use MULTI-CONTROL to select
SW CONTROL.
2
Press MULTI-CONTROL to display the
setting mode.
• Press BACK to return to the previous display.
3
Press MULTI-CONTROL to select the seg-
ment you wish to set.
Press MULTI-CONTROL repeatedly to switch
the segment in the following order:
REAR SP (rear speaker setti ng)-PREOUT
(RCA output setting)
4 Use MULTI-CONTROL to select the de-
sired setting.
Turn to change the setting.
When REAR SP (rear speaker setting) is se-
lected.
REAR SP:SUB W (subwoofer)-REAR SP:FULL
(full-range speaker)
When PREOUT (RCA output setting) is se-
lected.
PREOUT:SUB W (subwoofer)-PREOUT:REAR
(fu II-range speaker)
• When no subwoofer is connected to the rear
output, select REAR SP:FULL.
00
En
)
• When a subwoofer is connected to the rear
output, set for subwoofer REAR SP:SUB W.
_Notes
• Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoo(er output on page
23).
• If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
• Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
C!J
Switching the Ever Scroll
When Ever Scroll is set to ON, recorded text in-
formation scrolls continuously in the display.
Set to OFF if you prefer the information to
scroll just once.
1
Use MULTI-CONTROL to select
EVER SCROLL.
2
Press MULTI-CONTROL to turn the Ever
Scroll on.
• To turn the Ever Scroll off, press
MULTI-CONTROL again.
C!J
Activating the BT AUDIO source
You need to activate the BT AUDIO sou rce in
order to use a Bluetooth audio player.
• You can only operate this function when
Bluetooth adapter (e.g. CO-BTB200) is con-
nected to this unit.
1 Use MULTI-CONTROL to select
BTAUDIO.
2 Press MULTI-CONTROL to turn the
BT AUDIO source on.
• To turn the BT AUDIO source off, press
MULTI-CONTROL again.
C!J