Adjusting Loudness; Using Subwoofer Output; Adjusting Subwoofer Settings - Pioneer DEH-P70BT Operation Manual

Audio Adjustments
2 Push Multi-Control left or right to select
bass or treble.
Pushing Multi-Control left and Bass is dis-
played. Pusing Multi-Control right and Treble
is displayed.
3 Push Multi-Control up or down to ad-
just the level.
Each time Multi-Control is pushed up or
down, selected bass or treble level increases
or decreases. +6  6 is displayed as the level
is increased or decreased.
4 Turn Multi-Control clockwise to select
Bass (bass and treble frequency adjust-
ment).
Bass appears in the display.
# If the treble frequency has been previously ad-
justed, Treble will be displayed.
5 Push Multi-Control left or right to select
the desired frequency.
Each time Multi-Control is pushed left or
right, frequencies are selected in the following
order:
Bass: 4063100160 (Hz)
Treble: 2.5k4k6.3k10k (Hz)

Adjusting loudness

Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Use Multi-Control to select LOUD.
LOUD appears in the display.
2 Press Multi-Control to turn loudness
on.
Loudness level (e.g., Mid) appears in the dis-
play.
All manuals and user guides at all-guides.com
3 Push Multi-Control left or right to select
a desired level.
Each time Multi-Control is pushed left or
right, level is selected in the following order:
Low (low)Mid (mid)High (high)
4 To turn loudness off, press
Multi-Control again.
OFF appears in the display.

Using subwoofer output

This unit is equipped with a subwoofer output
which can be turned on or off.
1 Use Multi-Control to select Sub-W1.
Sub-W1 appears in the display.
# When the subwoofer controller setting is
Preout :FULL, you cannot select Sub-W1.
2 Press Multi-Control to turn subwoofer
output on.
Normal appears in the display. Subwoofer out-
put is now on.
# To turn subwoofer output off, press
Multi-Control again.
3 Push Multi-Control left or right to select
the phase of subwoofer output.
Push Multi-Control left to select reverse
phase and Rev. appears in the display. Push
Multi-Control right to select normal phase
and Normal appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Use Multi-Control to select Sub-W2.
Sub-W2 appears in the display.
Section
14
75
En