IpLink 2888 Getting Started Guide
IpLink 2888 front panel
Figure 3
shows IpLink 2888 LEDs, the LED definitions are listed in
Power
Activity
Ethernet 0
LED
Note
Power
Run
Ethernet Link
Ethernet Speed
10/100
Ethernet Speed
1000
Ethernet Activity
T1/E1 Link/Status
Rear and Front Panels
Ethernet 0
Ethernet 1
Link
1000
Link
Ethernet 0
Ethernet 0
100
Activity
Figure 3. IpLink 2888 front panel
Table 4. LED Descriptions
If an error occurs, all LEDs will flash once per second.
When lit, indicates power is applied.
When lit, the unit is in normal operation. Flashes once per second during
boot (startup).
On when the Ethernet connection on the corresponding port has a link indication.
When the Ethernet Link LED is on, then:
On when the Ethernet is connected to a 100Mb network.
•
Off when the Ethernet is connected to a 10Mb network.
•
On when the Ethernet is connected to a 1000Mb network.
•
Flashes when data is received or transmitted at the corresponding Ethernet port.
•
On = in frame, no errors
Flash = Error
•
Fast Flash = Signal detected but no frame synchronization or aquisition is in
•
process
Slow Flash = Framing synchronized, Signaling not established
•
table
4.
T1/E1 Port 3
T1/E1 Port 2
Ethernet 1
T1/E1 Port 1
Activity
T1/E1 Port 0
Ethernet 1
1000
Ethernet 1
100
Description
1 • General information
Model 2888 IpLink
18