Panasonic EASA-PHONE KX-T123211D Installation Manual page 63

1.
Turn the Power Switch ON.
2. Set the System Program Switch to " PITS" position.
The LCD on the KX-T123230 or KX-T123235 will show " SYS-PGM NO ?&' I.
l Be sure the handset of the extension connected to jack number
01 is in the cradle and the speakerphone button is off.
3. To program automatic line access number 9 and the phone
number 987-654-3210 into speed access code 00. (Refer to
page 3-5.)
KX-T123230 or KX-T123235 at extension connected to
jack number 01.
(Extension connected to jack number 01 must be a
KX-T123230 or KX-T123235.1
1.
Dial (01) or press the
Display
AUTO button.
Speed Dialing
2. Press the NEXT button. ' m;
3.
Dial (00) or press the
l If nothing is stored in
NEXT button.
access code " OO" ,
11
o If already stored the
automatic line access
number 9 and the phone
number 123-456-7890,
1oo:9-123-456_7891
4.
0 Dial " 9" .
0 Press " - " button.
@ Dial " 987" .
@ Press " - " button.
1oo:-987-654_32101
@ Dial " 654" .
@ Press " - " button.
@ Dial " 3210" .
5.
Press the MEMORY
button.
(oo:-987-654-32101
6. l To program the next access code, press the NEXT
button.
l To program a desired access code, press the SELECT
button and dial speed access code.
7.
Repeat steps 4 to 6.
8.
To return to the initial
program mode, press the ISYS_PGMl
END button.
4. Return the System Program Switch to " SET" position.
l To make program change, start from the beginning.
?_a
KX-T123211
I
If you make a mistake while programming,
1.
Press the " END" button.
2. Start programming procedure from the
beginning.
l You will hear a beep after pressing the
MEMORY button.
l The MEMORY indicator light will go on
when the MEMORY button is pressed,
and then the Indicator light will go out
when the NEXT or PREV button &pressed.