Panasonic EASA-PHONE KX-T123211D Installation Manual page 112

:..............,........until the desired CO number (01 through 12) appears
I" " " " " " " " " " " " " " " " " C= dial the trunk group number (1 through 8)
I
~INEXT*h~(IENDI
;m$akl
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
q
: trunk group number 1
q
: trunk group number 8 _- _
efault
CO 01 is assigned to Trunk group 1.
CO' 07 is assigned to Trunk group 7
CO 08,09, 10,ll and 12 are assigned to Trunk group 8.
AB=
El
: to assign the same on all 12 CO' s
mlil :onCOOl
mm :onCO 12 D
Description
When outside lines are grouped, an idle line
within the trunk group is automatically found and
connected when an outside call is placed.
A maximum 8 groups can be assigned.
For example, if subscribing with multiple
telephone service companies, the CO lines can be
grouped as shown below by each company.
Trunk Group 1
Trunk Group 2
Service Company A
Trunk Group 3
Service Company C
Refer to " Outward Dialing (Individual Trunk Group
Access)" on page 4-3 and " Flexible CO Button (To
Assign into Trunk Group Access Button)" on page
4-57.
2. Press the NEXT button.
" CO NO ? +" will be displayed.
3. Press the NEXT button or dial the CO number
(01 through 12).
" CO 01: TRK GRP-1" will be displayed and " 1"
will blink.
4. Dial the trunk group number (1 through 8).
5. Press the MEMORY button.
The LCD will stop blinking.
6.
l
To advance to the next CO number,
press the NEXT button.
l
To return to the previous CO number,
press the PREV button.
0 To go to the desired CO number,
press the SELECT button and then dial the
CO number.
7. Repeat steps 4 to 6, to program the trunk group
_.
number on the other CO lines.
6. To return to the initial program mode, press the
rrogrammmg
1. Dial (44).
" Trunk Group" will be displayed.
END button.
Programming Table
See page 7-13.
3-52