Panasonic EASA-PHONE KX-T123211D Installation Manual page 109

!.....................-unti I the desired CO number (01 through 12) appears
, ......................................
until the desired dial mode appears
;....................................................
. .
DTMF Mode . . . . . . default (all 12 CO' s)
Pulse Mode
Call Blocking Mode
AB=
q
:
to assign the same on all 12 CO' s
lolj?J : on CO 01
!
nr;il :onCO12
Description
Allows the user to select the dialing mode (tone,
pulse or call blocking) of each CO (Central Office)
line.
DTMF Dial Mode
The dial signal from the extension (with tone
or pulse dial mode) will be converted to TONE.
TONE will be transmitted to the Central Office.
PULSE Dial Mode
The dial signal from the extension (with tone
or pulse dial mode) will be converted to PULSE.
PULSE will be transmitted to the Central Office.
Call Blocking Mode
Set this mode on outside lines that can receive both
DTMF (Tone) and Pulse dial, but under contract with
the Central Office for Pulse dialing only.
When dialing the outside line using a touch
tone telephone, only Pulse dial is sent to the
Central Off ice.
Programming
1.
2.
3.
Dial (41).
" CO Dial Mode" will be displayed.
Press the NEXT button.
" CO NO ?+" will be displayed.
Press the NEXT button or dial the CO number
(01 through 12).
" CO 01 : DTMF Mode" will be displayed and
" DTMF Mode" will blink.
4.
Repeat pressing the SELECT button until the
desired dial mode isdisplayed.
5. Press the MEMORY button.
The LCD will stop blinking .
6.
l
To advance to the next CO number,
press the NEXT button.
l
To return to the previous CO number,
press the PREV button.
l
To go to the desired CO number,
press the SELECT button and then dial the
CO number.
7. Repeat Steps 4 to 6, to propgram the dialing
mode on the other central office lines.
6. To return to the initial program mode, press
the END button.
Conditions
l
If the KX-Tl23211 is connected to the Central
Office directly or installed behind a host PBX,
which receives both tone and pulse dials, the
KX-Tl23211 must be used only in the tone dial
mode.
0 If your extension is not a Proprietary
telephone but a standard telephone, and the
dial tone frequency of CO Lines is 600H2, the
KX-Tl23211 must be used only for the pulse
dialing mode for the CO Lines. -.
Programming Table
See page 7-12.
3-49