Table of Contents
Advertisement
Setup Menus
VIDEO menu
Item
Superimposed
No.
No.
display
600
VIDEO IN SEL
0000
0001
601
VIDEO INT SG
0000
0001
0002
0003
602
SDI IN MODE
0000
0001
605
INTERPOLATE
0000
0001
620
DOWNCON
MODE
0000
0001
0002
0003
0004
622
D/C RESP H
0000
0001
623
D/C RESP V
0000
0001
626
D/C ENH H
0000
0001
0002
0003
627
D/C ENH V
0000
0001
0002
0003
630
1080i 5
HD OUT
0000
0001
0002
1080i 5
SD OUT
0000
0001
0002
The underlining indicates the factory setting.
<Note>
Menu items No.620 through No.631 can make effect only when the optional HD-SD format converter board (AJ-
UDC150P) has been installed.
Setting
Superimposed
display
For selecting the video signal to be input.
INT SG
0: The internal signal selected by the VIDEO INT SG setting is selected.
SDI
1: The serial video signal input to HD SDI IN is selected.
For selecting the type of internal signal.
CB
0: The color bar signal is selected.
MB
1: The multi burst signal is selected.
RAMP
2: The ramp signal is selected.
BLACK
3: The black signal is selected.
For selecting the method used to process the HS SDI input.
DR OFF
0: The higher 8 bits whose lower 2 bits have been rounded off (rounded
up for 5 and above and rounded down for 4 and below) are recorded.
DR ON
1: The 8-bit signal which has been dynamically rounded is recorded.
For selecting the interpolation operation.
During slow playback, vertical interpolation is conducted automatically to
reduce the vertical movement of the playback pictures. However, this
operation can be forcibly turned off using this setting.
OFF
0: Interpolation is forcibly turned off.
AUTO
1: Interpolation is automatically turned on during slow playback.
For selecting the frame processing during down-conversion.
FIT_V
0: Side cut mode
FIT_H
1: Letter-box mode
FIT_HV
2: Squeeze mode
14:9
3: Semi letter-box 14:9
13:9
4: Semi letter-box 13:9
WIDE
For selecting the horizontal band width during down-conversion and line
STD
conversion.
WIDE
For selecting the vertical band width during down-conversion and line
STD
conversion.
0dB
For enhancing the horizontal contour during down-conversion and line
+1dB
conversion.
+1.5dB
+2dB
0dB
For enhancing the vertical contour during down-conversion and line
+1dB
conversion.
+1.5dB
+2dB
For selecting the format of the signal which is output to the HD SDI OUT
connectors when the SDTI input signal is in the 1080i format.
1080i
0: 1080i format (no conversion)
720p
1: 720p (line conversion)
1080i
2: 1080i format (no conversion)
For selecting the format of the signal which is output to the SD SDI OUT
connectors when the SDTI input signal is in the 1080i format.
480i
0: 480i format (down-conversion)
– – –
1: Muted
480p
2: 480p format (down-conversion)
14
Description of setting
E
D
N
E
C
C
[
[
[
[
[
[
[
[
[
[
[
Advertisement
Table of Contents
