Table of Contents
Advertisement
Setup Menus
BASIC menu
Item
Superimposed
No.
No.
display
005
SUPER
0000
0001
006
DISPLAY SEL
0000
0001
0002
007
CHARA H-POS
0000
0006
0037
008
CHARA V-POS
0000
0023
0032
009
CHARA TYPE
0000
0001
020
SYS FORMAT
0000
0001
031
OUT REF
0000
0001
0002
0003
The underlining indicates the factory setting.
Setting
Superimposed
display
For selecting whether the time code and other displays are to be
superimposed on the monitor (which has been connected to the HD SDI
OUT3 or SD SDI OUT3 connectors).
OFF
0: The displays are not superimposed.
ON
1: The displays are superimposed.
For selecting what is to be superimposed on the monitor (which has been
connected to the HD SDI OUT3 and SD SDI OUT3 connectors).
TIME
0: Time only
T&STA
1: Time and operation mode
T&S&M
2: Time, operating mode and mode
<Notes>
O The mode display accords with the format as shown below:
DVCPRO (HD) 5 DVCPRO_HD
O When T&S&M has been selected and a warning occurs, the information
of the warning will be displayed.
For further information, refer to "Warning messages and DIAG display."
0
For setting the horizontal position of the superimposed characters.
:
:
<Note>
6
While this item is being set, the superimposed display is output from the
:
:
HD SDI OUT3 or SD SDI OUT3 connectors in accordance with the
37
settings selected for DISPLAY SEL and CHARA TYPE even if OFF has
been selected as the SUPER setting. However, it will be in accordance
with the SUPER OFF or ON setting when the menu setting mode has
been exited.
0
For setting the vertical position of the superimposed characters.
:
:
<Note>
23
While this item is being set, the superimposed display is output from the
:
:
HD SDI OUT3 and SD SDI OUT3 connectors in accordance with the
32
settings selected for DISPLAY SEL and CHARA TYPE even if OFF has
been selected as the SUPER setting. However, it will be in accordance
with the SUPER OFF or ON setting when the menu setting mode has
been exited.
For selecting the type of characters used to display the superimposing,
setup menus, etc.
WHITE
0: White characters on a black ground.
W/OUT
1: White characters with a black border.
For selecting the HD format to be handled by the unit.
1080i
0: The 1080i format is selected.
720p
1: The 720p format is selected.
For selecting the SDI output reference signal.
AUTO
0: When the HD REF signal is input, this signal is used as the reference
signal. When the HD REF signal is not input and the SD REF signal is
input, SD REF is used as the reference signal.
When neither the HD REF signal nor the SD REF signal is input, the
SDTI signal is used as the reference signal.
When HD REF, SD REF or SDTI signals are not input, the internal sync
signal is used as the reference signal.
INPUT
1: When the SDTI signal is input, the SDTI input is used as the reference
signal.
HD_REF
2: The signal which has been input to the HD REF IN connector is used
as the reference signal.
SD_REF
3: The signal which has been input to the SD REF IN connector is used
as the reference signal.
Description of setting
<Format>
<Display>
12
E
D
N
E
C
C
[
[
[
[
[
[
[
[
[
[
[
[
[
Advertisement
Table of Contents
