Panasonic KX-TD612E Features Manual page 236

1.1 General Features
7.
Ring : shows the ring duration of the incoming call as Minutes/Seconds.
8.
Duration : shows the duration of the call as Hours/Minutes/Seconds.
9.
Cost : shows the amount of charge in matter units or currency units (e.g. ).
10.
Acc Code : shows the account code appended to the call.
11.
CD : shows the condition code.
T :Transfer
F :Call Forwarding to CO line
R : Receive an incoming call
A : Answer an incoming call
N : No answer an incoming call
D: Doorphone Call Forwarding to CO line
Conditions
• When programmed for outgoing toll calls only, printing occurs only for calls which start
with the numbers stored in any Denied Code Table from levels 2 to 6.
• This system can store information on up to 100 calls. If more calls are initiated or received,
stored records are deleted starting from the oldest one.
• It is possible to select the SMDR format, page length, skip perforation and page width. If
80 characters for page width is selected, the last 5 digits of account codes are not printed
out.
• This data is not deleted when you restart the system.
• "(8) Cost" is printed out in the format selected in programme "[117] Charge Display
Selection."
• It is programmable to enable or disable the printout of secret dial numbers.
• If the account code stored in location 01 of the programming table is dialled, the dialled
phone number is not printed out to SMDR (Private Call). Refer to lines 7 and 8 on the
example of printed call records.
• When the paper of the printer runs out or the printer is out-of-service, the indication "Check
Printer" is displayed on the telephone of Operator 1.
• It is possible to select whether or not to print out the data when the system receives a call
and a call is answered.
• It is possible to select whether the account code is printed out or not. If it is not printed out,
it is shown in dots.
Installation Manual References
• 2.4.9 Printer and PC Connection
236 Features Guide