Direct In Line (Dil) - Panasonic KX-TA824 Feature Manual

1.1 General Features
Mode
Call Blocking
Conditions
• Automatic Configuration for Outside (CO) Line Type
The dialing mode of connected outside (CO) lines is automatically assigned after restarting the PBX
using the System Clear Switch or through system programming (
system programming in [401] Dial Mode and [402] Pulse Speed is required unless the dialing mode of
the connected outside (CO) lines is Call Blocking. If your telephone company can receive both DTMF
and Pulse signals, the PBX selects an outside (CO) line type according to the following priority:
DTMF Pulse (High)
• The pulse rate for outside (CO) lines that have been set to "Pulse" or "Call Block" mode (
Speed) should be selected depending on your telephone company or a host PBX. There are 2 pulse
rates: Low (10 pps) and High (20 pps).
Programming Manual References
[PT Programming]
[119] Redialing after Pulse to Tone Conversion
[401] Dial Mode
[402] Pulse Speed
[999] System Data Clear
[PC Programming]
8.4 System Data Clear
9.1.11 Detail [1-10]—CO—Redialing after Pulse to Tone Conversion
9.3.3 Detail [3-3]—Dial Mode, Pulse Speed
Feature Manual References
1.1.5 Automatic Configuration for Outside (CO) Line Type
1.1.104 Pulse to Tone Conversion

1.1.40 Direct In Line (DIL)

Description
Directs incoming outside (CO) line calls to a preprogrammed destination based on the outside (CO) line
carrying the call. Each outside (CO) line can have a different destination for each time service mode.
[Programming Example]
The table can be programmed for each outside (CO) line.
54 Feature Manual
If your telephone company or a host PBX can receive both DTMF and
Pulse signals but the contract specifies Pulse lines, select this mode.
When dialing with a touch-tone telephone, only Pulse signals will be sent
to the telephone company.
Pulse (Low)
Description
[999] System Data Clear). No
[402] Pulse