Panasonic KX-TA824 Feature Manual page 160

1.1 General Features
[DTMF Status Signals]
Status
Ringback Tone
Busy Tone
Reorder Tone
DND Tone
Answer
Confirm
Disconnect
FWD to VM Ringback Tone
FWD to VM Busy Tone
FWD to Extension Ringback
Tone
System Programming
The following settings to enable Inband (DTMF) Integration must be programmed through system
programming to match the settings of the VPS. This example uses a Panasonic KX-TVS series VPS/KX-
TVA series VPS, which can be connected to up to 4 extension jacks of the PBX.
[Programming Example: Voice Mail Table]
DTMF Integration*
Enable
[103] DTMF Integration
* 1
2 [102] DTMF Integration Port
*
In this example:
To enable the VM Hunting Chain and AA Hunting Chain, program as follows:
1)
Assign all Voice Mail extensions to one extension group in [600] Extension Group.
2)
Assign "Enable" to the group in [100] Hunting Group Set.
160 Feature Manual
The PBX is ringing the corresponding
extension.
The called extension is busy.
The dialed number is invalid.
The called extension has set DND (
Do Not Disturb (DND)).
The called extension has answered the call.
The PBX confirms that a feature (such as
Message Waiting) has been set or canceled on
the extension.
The caller has hung up.
The called extension has set FWD to VPS (
1.1.10 Call Forwarding (FWD)—SUMMARY)
and the PBX is calling another port of the VPS.
The called extension has set FWD to VPS and
all ports of the VPS are busy.
The PBX is calling an extension other than the
one dialed, most likely because the called
extension has set its calls to be forwarded to
another extension or because it is a member of
an idle extension hunting group (
Extension Hunting).
Voice Mail Port*
1
Jack 07 Jack 08
Enable Enable
Condition
1.1.44
1.1.67 Idle
2
Jack 15 Jack 16
Disable Disable
DTMF Status Signal
1
2
3
4
5
9
#9
6
7
8