Type
Tone 1
Tone 2
Tone 3
Tone 4
Tone 5
Feature Manual References
2.2.1 Tones/Ring Tones
1.1.39 Dial Type Selection
Description
The dialing mode can be selected for each outside (CO) line through system programming (
Mode) regardless of the originating extension (dependent on the contract with the telephone company).
Mode
DTMF (Dual Tone Multi-
Frequency)
Pulse (Rotary)
A normal dial tone is heard when none of the features listed for dial tones 2
through 5 have been set.
Heard when any of the following features is set.
•
Absent Message
•
Background Music (BGM) (for proprietary telephones [PTs] only)
•
Call Forwarding (FWD)
•
Call Pickup Deny
•
Data Line Security
•
Do Not Disturb (DND)
•
Extension Lock
•
Hot Line (for single line telephones [SLTs] only)
•
Message Waiting (for PTs only)
•
Remote Extension Lock
•
Timed Reminder
Heard when any of the following features is performed.
•
Account Code Entry
•
Answering a call from Timed Reminder
•
Going off-hook with an SLT that has messages waiting
Heard when going off-hook if new voice messages have been recorded (Built-in
Voice Message [BV]).
Heard when going off-hook if the remaining voice message recording time is less
than 5 minutes or if 125 voice messages have been recorded (Built-in Voice
Message [BV]).
Numbers dialed by an extension user are transmitted to the outside (CO)
line using tones. If this PBX is installed behind an existing host PBX,
select this mode as necessary. If your telephone company or a host PBX
can receive both DTMF and Pulse signals but the contract specifies
DTMF lines, select this mode.
Numbers dialed by an extension user are transmitted to the outside (CO)
line using pulses.
Description
Description
1.1 General Features
[401] Dial
Feature Manual
53