Disconnect Time - Panasonic EASA-PHONE KX-T61610 Installation Manual

,_._._..__._ until the desired CO number appears
[35] [NEXT] ,Ni+XT] [SXECT] [MEkjORY][END]
;] [NEXT] [A] [SELECT] [MEMORY][END]
-
'--..-...-_..-.--..-.--.....
A=[*]: to assign the Same 011 all
6
CO's
Description
A certain amount of time is needed for an
outside call to be released, this is necessary so
that a new call may be aitempted after discon-
necting with the previous call.
There are two choices available, 1.5 and JO
seconds.
The time you select must be longer than the
requirements
from
your Central Office or host
PBX.
Programming
I. Dial (35).
"DISCONNECT TIME" will be displayed.
2. Press the NEXT button.
"ENTER CO NO" will be displayed.
6. Repeat steps 3 to 5, to set the disconnect time
for the other CO's.
7. To return to the initial program mode, press
the END button.
Conditions
l
When you start the programming from step 1,
you may dial the desired CO number instead
of the NEXT button at step 3.
@The PREV button allows you to go to the
previous CO for displaying the disconnect
time.
Example:
l
4.0 see on all 6 CO=
[35] [NEXT] [++I [SELECT] [MEMORY] [END]
3. Press the NEXT button.
Programming Table
"CO 1: 1.5 SEC" will be displayed and
"1.5 SEC" will blink.
See page 6-20.
4. Press the SELECT button to alternate be-
tween 1.5 set and 4.0 sec.
.,. .
5. Press the MEMORY button.
The LCD will stop blinking.
3-50