Dial Mode Selection - Panasonic EASA-PHONE KX-T61610 Installation Manual

I~-~~---~-~~~--~ until the desired CO number appears
[0orq] [NEXT] [Al [SELECT] [MEMORY] [END]
pI'[+$]: to assign the same on all 6 CO'S
Description
Conditions
Allows the user to select rhe dialing mode (tone
or pulse) of each CO (Central Ofice) line.
*TONE Dial Mode
The dial signal from rhe extension (ivith tone or
pulse dial mode) will be converted to TONE.
TONE will rhen be transmitted to the Cenrral
Office.
l
PlJLSE Dial Mode
The dial signal from rhe extension (with tone ot
p&e dial mode) will be converted to PULSE.
PULSE will then be transmitted to the Central
Ofice.
Programming
1. Dial (04).
"CO DIAL MODE" will be displayed.
2. Press the NEXT button.
"ENTER CO NO" will be displayed.
3. Press the NEXT button.
"CO 1: TONE"
will be displayed and
"TONE" will blink.
4. Press the SELECT button fo alternate
be-
tween TONE and PULSE.
5. Press the MEMORY butron.
-The LCD blinking will stop.
6. Repeat sreps 3 to 5, to progratn the dialing
mode on the other central ofice lines.
7. To return to rhe initial program mode. press
the END burton.
0 When you start the programming frotn step 1,
you
may dial rhe desired CO number instead
of the NEXT button at step 3.
l
The PREV button allows you to see the entry
status in the previous CO dial mode.
'If the KX-T61610 is connected lo rhe Central
Office directly or installed behind a host PBX,
which receives both tone and pulse dialing
mode, the KX-T61610 must be used only in
the lone dial mode.
'If your extension is not a KX-T61630,
KX-T61620,
KX-T61650,
KX- T30830,
KX-T30820 or KX-T308SO but a standard
telephone, and the dial tone frequency of CO
Lines is 600 Hz, the KX-T61610 tnust be used
only for the pulse dial mode of CO Lines.
Example:
l
TONE on the CO 1=
[04] [NEXT] [l] [MEMORY] [END]
or
[04] [NEXTJ [NEXT] [MEMORY] [END]
*PULSE on the CO 2=
[04] [NEXT] [2] [SELECT] [MEMORY] [END]
or
[04] [N&T] [NEXT] [NEXT] [SELECT]
[MEMORY] [END]
Programming Table
See page 6-14.