Panasonic EASA-PHONE KX-T61610 Installation Manual page 188

01
>
[12] [NEXT] [C] [MEMORY] [END]
-.
:................ until the desired memory location number appears
Description
For Service Class 2 or 3 (see "Toll Restriction")
up to 10 or 20 phone numbers can be selected for
use in toll dialing.
Phone numbers programmed will be denied. Ali
extensions programmed
for
Service Class Selec-
tions shall be assigned to the same denied code
assignment plan.
Memory locations 00-09 are restricted by classes
2 and 3.
Memory locations lo-19 are restricted by only
class 3.
5. To advance to the next memory location num-
ber, press the NEXT button.
To return to the previous memory location
number, press the PREV button.
To go to a desired memory location number,
press the SELECT button and dial the
mern-
ory
location number.
6.
Repeat steps 3 to 5.
7. To return to the initial programming mode,
press the END button.
Programming
Conditions
1 1.
Dial (12).
l
Each phone number should consist
of
7 digits.
"ENTER CODE NO." will be displayed.
l
'r*jCt' substitutes
for
any numbers, see the
fol-
lowing example.
2. Dial the
memory
location number (00
through 19) or press the NEXT button.
Example:
When dial (00) or press the NEXT button;
-When nothing is stored in memory location
number "OO", "0O:NOT STORED" is dis-
played.
-When the dial number lGHG+++?H% has
been stored, "OO:l?H%++cJc++" will be dis-
played.
3. Dial the 7-digit phone number.
l
T6 erase a wrong entry, press the CLEAR
button.
4. Press the MEMORY-hutton.
l
The MEMORY indicator will be lit.
Example:
To deny extension 14 to have access to the phone
number 09 and 8 in the service class 2.
Step l...[ll] [14] [SELECT] [MEMORY] [END]
Step 2...[12] [NEXT] [09WHG+*]
[MEMORY] [NEXT] [8.HW%-H]
[MEMORY] [END]
09XXCiCJCJC...disables the phone numbers
which
start
with 09.
. . .
I
8jC*G%CSCJCJC...disables the phone numbers
which have 8 on thefirst digit.
/
Programming Table
See page 37. .'