Trane Tracer ZN510 Installation, Operation, And Programming page 16

Zone Sensor Features
Fan Switch (Optional)
The zone sensor fan switch provides
the controller with an occupied (and
occupied standby) fan request signal
of or . If the fan control
OFF AUTO
request is communicated to the
controller, the controller ignores the
hardwired fan switch input and uses
the communicated value. The zone
sensor fan switch signal can be
enabled or disabled through
configuration in the ZN510
controller.
or Buttons
ON CANCEL
Momentarily pressing the
ON
Table 6: Zone Sensor Options
Part Number:
X13510628010
Description:
Space temperature (0.2 C
resolution).
Internal setpoint.
Communication jack.
Vertical case with Trane logo
Part Number:
X13510606010
Description:
Space temperature (0.2 C
resolution).
External setpoint.
Communication jack.
Vertical case with Trane logo
Zone Sensor
during unoccupied mode places the
controller in occupied bypass mode
for 120 minutes. You can adjust the
number of minutes in the unit
controller configuration using
Trane's service tool, Rover. The
controller remains in occupied
standby mode until the override
timer expires or until the
button is pressed.
Communication Jack
Use the RJ-11 communication jack
as the connection point from Rover
to the communication link (when the
communication jack is wired to the
button communication link at the
16
controller). By accessing the
communication jack via Rover,
entrance to all controllers on the link
may be gained.
CANCEL
RT1
10K OHM @
25 °C ± 2°C
VR1
R7 1K
ADJ USTABLE
SETPOINT
COMMUNICATIONS
MJ 1
J ACK
RT1
10K OHM @
25 °C ± 2°C
VR1
R7 1K
ADJ USTABLE
SETPOINT
COMMUNICATIONS
MJ 1
J ACK
ZONE
1
SIGNAL (COMMON)
2
200
CSP
3
COMM HIGH (+ )
4
COMM LOW (-)
5
ZONE
1
SIGNAL (COMMON)
2
200
CSP
3
COMM HIGH (+ )
4
COMM LOW (-)
5