Unit View - Trane CGAM Installation & Operation Manual

Controls Interface

Unit View

Unit view is a summary for the system organized by chiller subsystem. This provides an overall
view of chiller operating parameters and gives you an "at-a-glance" assessment of chiller
operation.
The Control Panel tab displays important operating information for the unit and allows you to
change several key operating parameters. The panel is divided into four or more sub-panels
(depending on the number of circuits in the unit).
The Operating Mode tab displays the unit, circuit and compressor top level operating modes.
The Hours and Starts tab displays the number a hours (total) a compressor has run and the number
of times the compressor has started. This window plays a key role in evaluating maintenance
requirements.
Upon successful Local Connect TechView will display UNIT VIEW.
CGAM Unit View is shown below:
Figure 81. Unit View
The Unit View displays the system, control point name, value and unit of measure. It reflects active
setpoints and allows you to make changes.
128 CG-SVX17D-EN