Trane CGAM Installation & Operation Manual page 133

Table 57. Unit View Tabs - Detail
Tab
Evaporator Water Pump 1 Starts
Evaporator Water Pump 1 Running Time
Heat Recovery Tab
Partial heat recovery (PHR) Fan Control
PHR Leaving Water Temperature Setpoint
PHR Leaving Water Temperature Adjustment
Generic Monitoring Tab
Generic Temp Sensor
Generic Pressure Sensor
Generic Analog Monitor
Generic Low Volt Monitor
Generic High Volt Monitor
The items that can be modified show up in white. The items that cannot be modified show up in
gray.
Figure 83. Fields in White
To change the setpoint enter a new value for the setpoint into the text field.
Figure 84. Change Setpoint
If the entered value is outside the given range, the background turns red.
Figure 85. Change Out of Range
CG-SVX17D-EN
Item
Type Units
Status Starts
Status Time (Sec to HH:MM)
Setting Disable/Enable
Setting Temp (°C)
Setting Delta Temp (°C)
Status Temp (°C)
Status Pressure (kPa)
Status Current (mA)
Setting Open/Closed
Setting Off/On
Controls Interface
Min Max
Value Value
Default
Value
133