Download Print this page

Trane CVGF-SVN02B-E4 Installation Manual page 6

Gear-driven centrifugal water-cooled liquid chillers, unit model cvgf 400-1000 ton units (50 and 60 hz)

Advertisement

Unit Nameplates
The CVGF unit nameplate
(Figure 2 shows the nameplate
location) is applied to the
exterior surface of the control
panel. The starter nameplate is
located inside the starter panel.
The unit nameplate provides the
following information:
• Unit model
• Unit serial number
• Unit device number - identifies
unit electrical requirements
- Lists correct operating
charges of HFC-134a and
lubrication oil
- Lists unit test pressures and
maximum working pressures
The starter nameplate provides
the following information:
• Panel model number
• Rated load amps
• Voltage
• Electrical characteristics -
starter type, wiring
• Options included
6
General
Information
Unit Inspection
When the unit is delivered, verify
that it is the correct unit and that
it is properly equipped.
Inspect all exterior components
for visible damage. Report any
apparent damage or material
shortage to the carrier and make
a "unit damage" notation on the
carrier's delivery receipt. Specify
the extent and type of damage
found and notify the appropriate
Trane Sales Office.
Do not proceed with installation
of a damaged unit without sales
office approval.
Inspection Checklist
To protect against loss due to
damage incurred in transit,
complete the pre-commissioning
checklist, which can be obtained
from your Trane representative.
• Inspect the individual pieces of
the shipment before accepting
the unit. Check for obvious
damage to the unit or packing
material.
• Inspect the unit for concealed
damage as soon as possible
after delivery and before it is
stored. Concealed damage
must be reported within 10
days after receipt.
• If concealed damage is
discovered, stop unpacking the
shipment. Do not remove
damaged material from the
receiving location. Take photos
of the damage, if possible. The
owner must provide reasonable
evidence that the damage did
not occur after delivery.
• Notify the Trane sales
representative and arrange for
repair. Do not repair the unit,
however, until damage is
inspected by the transportation
representative.
CVGF-SVN02B-E4

Hide quick links:

Advertisement

loading

This manual is also suitable for:

Cvgf400Cvgf1000Cvgf500Cvgf650Cvgf700Cvgf800