Arming Your System - DSC MAXSYS PC4020 Instruction Manual

Keypads
Several LCD keypads will be installed throughout the protected premises,
usually one at each entry/exit door. Some keypads are programmed only
to access a single partition. These are called partition keypads.
If required, the system may have a global keypad. A global keypad can
access any partition. When you enter your access code at a global keypad,
you will be asked which partition you would like to arm. The keypad will
only offer the partitions available for your access code.
The keypad will display the message "Enter Your Access Code" when it
is not in use. Sometimes, it may display the time and date. Whatever the
display, enter a valid access code on the keypad to access the system.
Audio Help
If your security system has an audio matrix module (PC49XX and intercom
stations) and an Escort4580 connected, it can provide step-by-step audio
instructions through the intercom stations. Access the help function by
pressing and holding for 2 seconds the "Help" button on any system
keypad. The system will prompt you over the intercom stations.
NOTE: If a user is accessing the Escort locally over the telephone line,
the Help button will not work.

1.2 Arming Your System

1. Prepare the partition to be armed by closing all protected doors and
windows. Also, stop any movement in areas covered by motion
detectors.
2. If the time and date appears on the LCD keypad display, press the
[#] key. The "Enter Code to Arm System" message should appear. If
the display reads "Secure System Before Arming," ensure that all
doors and windows have been shut and that all motion has ceased.
3. When you see the "Enter Code to Arm System" message, enter your
4- or 6-digit access code. If the access code was entered incorrectly,
the keypad will beep steadily for two seconds.
For Single-Partition Access Codes
When a single-partition access code is entered, the system will only arm
the partition your code has access to. The "Exit delay in Progress" message
will be displayed, the Armed light will turn on, and the keypad will beep
three times quickly. The exit delay will begin, providing up to two minutes
for you to exit the partition without causing an alarm.
Exit the premises through the designated exit/entry door. A timer will
appear in the right side of the LCD keypad display indicating the
remaining time in the exit delay period. When the allowed exit time expires,
the partition will be armed. The message "Enter Code to Disarm System"
will appear on the keypad.
S e c t i o n 1 : G e n e r a l S y s t e m O p e r a t i o n
5