Table of Contents
Advertisement
PPTP/L2TP Client
Mode
ISP Access Setup
MTU
PPP Setup
IP Address
Assignment
Method(IPCP)
Vigor2955 User's Guide
Click Enable PPTP to enable a PPTP client to establish a tunnel
to a DSL modem on the WAN interface.
Click Enable L2TP to enable a L2TP client to establish a tunnel
to a DSL modem on the WAN interface.
Click Disable to disable PPTP/L2TP client mode. All the settings
configured in this page will be invalid.
Server Address - Specify the IP address of the PPTP server.
Specify Gateway IP Address - Specify the WAN IP address for
the router if the server is not in the same subnet.
Username -Type in the username provided by ISP in this field.
Password -Type in the password provided by ISP in this field.
Index (1-15) in Schedule Setup - You can type in four sets of time
schedule for your request. All the schedules can be set previously
in Application – Schedule web page and you can use the number
that you have set in that web page.
Mean maximum transmission unit of one packet. The default value
is 1442.
PPP Authentication - Select PAP only or PAP or CHAP for PPP.
Idle Timeout - Set the timeout for breaking down the Internet after
passing through the time without any action. This setting is active
only when the Active on demand option for Active Mode is
selected in WAN>> General Setup page.
Fixed IP - Usually ISP dynamically assigns IP address to you each
time you connect to it and request. In some case, your ISP provides
service to always assign you the same IP address whenever you
request. In this case, you can fill in this IP address in the Fixed IP
field. Please contact your ISP before you want to use this function.
Click Yes to use this function and type in a fixed IP address in the
box.
Fixed IP Address -Type a fixed IP address.
WAN IP Alias - If you have multiple public IP addresses and
would like to utilize them on the WAN interface, please use WAN
30
Advertisement
Table of Contents
