Table of Contents
Advertisement
D
e
t
a
i
l
s
D
e
t
a
i
l
s
To use PPPoE as the accessing protocol of the internet, please choose Internet Access from
WAN menu. Then, select PPPoE mode. The following web page will be shown.
PPPoE Client Mode
ISP Access Setup
WAN Connection
Detection
PPP/MP Setup
Vigor2955 User's Guide
P
a
g
e
f
o
r
P
P
P
o
E
P
a
g
e
f
o
r
P
P
P
o
E
Click Enable for activating this function. If you click Disable, this
function will be closed and all the settings that you adjusted in this
page will be invalid.
Enter your allocated username, password and authentication
parameters according to the information provided by your ISP. If
you want to connect to Internet all the time, you can check Always
On.
Username – Type in the username provided by ISP in this field.
Password – Type in the password provided by ISP in this field.
Index (1-15) in Schedule Setup - You can type in four sets of time
schedule for your request. All the schedules can be set previously
in Application – Schedule web page and you can use the number
that you have set in that web page.
Such function allows you to verify whether network connection is
alive or not through ARP Detect or Ping Detect.
Mode – Choose ARP Detect or Ping Detect for the system to
execute for WAN detection.
Ping IP – If you choose Ping Detect as detection mode, you have
to type IP address in this field for pinging.
TTL (Time to Live) – Display value for your reference. TTL
value is set by telnet command.
PPP Authentication – Select PAP only or PAP or CHAP for
PPP.
Idle Timeout – Set the timeout for breaking down the Internet
after passing through the time without any action. This setting is
26
Advertisement
Table of Contents
