Lighting Panel - Volvo S40 Owner's Manual

General
Thumbwheel for headlamp levelling
Light switches
Thumbwheel for adjusting display and
instrument lighting
Front fog lamps*
Opening the fuel filler flap
Rear fog lamp
Posi- Specification
tion
Automatic/deactivated dipped
beam. Only main beam flash.
Position/parking lamps
Automatic dipped beam. Main
beam and main beam flash
work in this position.
Headlamp levelling
The load in the car changes the vertical align-
ment of the headlamp beam, which could daz-
zle oncoming motorists. Avoid this by adjusting
the height of the beam.
1. Turn the remote control key to position II.
2. Turn the headlamp control (2) to one of the
end positions.
3. Roll the control (1) up or down respectively
to raise or lower beam alignment.
Cars with Dual Xenon headlamps* have auto-
matic headlamp levelling, so there is no control
(1).
02 Instruments and controls
Position/parking lamps
Position/parking lamps can be switched on
irrespective of remote control key position.
Turn the headlamp control (2) to the centre
position.
When the remote control key is in position II the
position/parking lamps and number plate light-
ing are always on.
Headlamps
Automatic dipped beam*
Dipped beam comes on automatically when
the remote control key is turned to position II,
except when the headlamp control (2) is in the
centre position. If necessary, the automatic
dipped beam can be deactivated. Volvo rec-
ommends that this is performed by an author-
ised Volvo workshop.
Automatic dipped beam, main beam
1. Turn the remote control key to position II.
2. Dipped beam is activated by means of
turning the headlamp control (2) clockwise
to the end position.
3. Main beam is activated by means of mov-
ing the left-hand stalk switch towards the
steering wheel to the end position and
releasing it, see page 58.
*
Option/accessory, for more information, see Introduction.

Lighting panel

02
55