Max. Flow Temp - Viessmann VITOCAL WPR 300 Service Instructions Manual

Compressor control settings
The control settings for the compressor are explained below.
Parameters with the numbers 50xx
always relate to the first compressor
stage, whereas the numbers 51xx
describe the identical parameters of
the second compressor stage.
5000 Enabling !
Enabling the compressor stage.
"Yes" Compressor stage is used.
"No" Compressor stage is not
used, e.g. in case of a fault.
Note
To enable compressor stage 2, para-
meter 5100 must be set to "Yes".
5001 Max. flow temp §
Secondary circuit maximum flow temperature.
!
Please note
Flow temperatures which are
too high can cause appliance
damage.
Never set the maximum flow
temperature higher than speci-
fied for the corresponding type
(see following table).
Compressor control settings
Note
Parameters of the second compressor
stage are only visible in the control
unit if this stage is available and has
also been activated in the control unit
via parameter 5100.
Menu
& "Device settings"
& "Programming"
& "Compressor"
& "Release"
Delivered condition
Setting
Yes
Yes/No
91