Figure 2-3 Installing Rails - NEC Express5800/A1160 Installation Manual

Install
the Cell Rail Assemblies
2. Beginning with either the front or back of the rail, insert the holding tabs in the
specified locations and push down until the locking spring clicks into place.
3. Repeat on the other end of the rail
4. Repeat steps 1 through 3 to install the other rail.
To remove a rail, press in the locking spring with your finger or a flat-blade screwdriver
and push up on the rail.
Installing Rails in a Cabinet with Round-Hole Brackets
If you have a multiple-cell system, perform the following procedure for each set of rails
for all cells before installing the cells:
1. Locate the bracket conversion kit that is provided with the rails to convert the
square-hole brackets for use in a cabinet with round-hole brackets. The kit includes
two metal brackets, four screws, and two rail support pins for each rail.
2. Attach a rail support pin on each metal bracket. This pin is used to ease the
2-4

Figure 2-3 Installing Rails