Exhaust Hose Installation - SPT WA-8070E Instructions Manual

Exhaust hose installation:

Install or remove the exhaust according to usage
mode:
Fig.10
COOL or AUTO mode
FAN or DRY mode
1. Extend the end of exhaust hose by couple inches
and attach Adaptor B to hose. (Fig.10)
Fig.11
2. Align the exhaust hose to the channels of the air
outlet opening (back of unit) and push in firmly,
according to arrow direction on Fig.11.
IMPORTANT
KEEP CURVE OF EXHAUST HOSE SMOOTH,
Fig.12
WITHOUT ANY KINKS OR SHARP BENDS. Refer to
Fig.12 & 13.
Fig.13
Continuous Water Drainage:
1. Remove drain plug from back of unit. (Fig.14)
2. Attach drain hose to the opening. ¾" hose can be
purchased locally. (Fig.15)
3. Direct other end of hose directly over drain area.
Fig.14
Note: Make sure the connection between the hose and
unit is tight and without leak.
Continuous drainage is highly recommended when
unit is used in DRY mode.
Fig.15
Emptying the Built-In Water Tank
When the water level of the built-in bottom tray
reaches a predetermined level, the unit beeps 8 times
and panel displays "P1". At this time the Cooling or
Dehumidifying process will immediately stop.
Fig.16
However, the fan motor will continue to operate.
Carefully move the unit to a drain location (or have a
container placed under the spout), remove the bottom
drain plug and let water flow out. (Fig.16). Restart the
machine and "P1" symbol should disappear. If the
error persists, call for service.
Note: be sure to replace the bottom drain plug before
restarting the unit.
9
Install
Remove