SIIG UltraATA 133 PCI Quick Installation Manual page 11

For Existing 64-bit Windows XP/Server 2003 Installation
1. Install the board and boot up Windows.
2. At the Found New Hardware Wizard:
XP (w/SP1 or earlier)/Server 2003: continue to step #3
XP (w/SP2 or later)/Server 2003 (w/ SP1 or later): select
No, not at this time, then click Next
3. Insert the driver CD, select Install the software
automatically (Recommended), then click Next.
Note:
automatically after inserting driver CD
4. Click Finish, remove the driver CD and restart
Windows to complete the installation.
To Verify Windows 2000/XP/2003 Installation
1. Right click My Computer and click Manage.
2. Select Device Manager.
3. Double click SCSI and RAID Controllers, then
double click Silicon Image SiI 0680 ATA/133
Controller to display driver properties.
4. A message This device is working properly is displayed
in the dialog box, the driver has been correctly
installed.
32-bit Windows Vista™
For New Windows 32-bit Vista Installation
1. Install the board and follow Microsoft procedures
to install Windows accordingly.
2. Restart your system when prompted during
Windows' installation.
3. At Where do you want to install Windows?, click
Load Driver.
Most systems will install the driver
11