Receiving Error Messages; This Document Is The Sole And Exclusive Property Of Wavecom. Not To Be Distributed Or Divulged Without Prior Written; Agreement - Wavecom Integra M2106+ Product Specification

7.3

Receiving error Messages

®
If the Wireless CPU returns an 'error' message on an attempted transmission of data or voice signals, refer
to the table below for possible causes and solutions:
If the Wireless CPU
returns
Error
©Confidential

This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without prior written

agreement.

WA_DEV_M2106+_PTS_003-001
Table 8: Solutions for error messages
®
Then ask
Is the Wireless CPU
on the network?
Is the Wireless CPU
an incoming call or is it already in
communication?
Is the selected bearer type
supported by the called party and
the network?
Is the received signal strong
enough?
Is the antenna compliant with
requirements and correctly
connected?
Corrective Action
Refer to section 6.5.3.3 to check that
®
registered
the Wireless CPU
®
receiving
End any communication using the
Ensure that the selected bearer type
is supported by the called party and
Ensure that the semicolon (;) is typed
immediately after the phone number
in the AT command.
e.g. ATD######;
Refer to section 6.5.3.2 to check the
strength of the received signal.
Refer to Table 4 for antenna
requirements and antenna connection
Integra M2106+
Erreur ! Style non défini.
®
is registered on
the network.
ATH command.
the network.
check.
Page: 71 / 77
April, 2007