Table of Contents
Advertisement
6.2 Receiving "ERROR" Message
The M1306B returns an "ERROR" message (in reply to an AT command) in the
following cases:
•
AT command syntax is incorrect: check the command syntax (refer to "AT
Commands Interface Guide" [7]),
•
AT command syntax is correct, but transmitted with wrong parameters:
•
Enter the
AT+CMEE=1
the verbose method, which includes the error codes.
•
Enter again the AT command which previously caused the reception of
"ERROR" message in order to get the Mobile Equipment error code.
When the verbose error report method is enabled, the response of the M1306B in
case of error is as follows:
•
Either +CME ERROR: <error result code>,
•
Or +CMS ERROR: <error result code>.
Refer to "AT Commands Interface Guide" [7] for error result code description and
further details on the
Note: It is strongly recommended to allways enable the verbose error report method
to get the Mobile Equipment error code (enter
6.3 Receiving "NO CARRIER" Message
If the M1306B returns a "NO CARRIER" message upon an attempted call (voice or
data), then refer to the table below for possible causes and solutions.
confidential ©
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged
without prior written agreement.
WM_PRJ_M13_UGD_001 -003
command in order to change the error report method to
command.
AT +CMEE
Fastrack M1306B User Guide
command).
AT +CMEE=1
Troubleshooting
Page: 38 / 65
November 11, 2006
Advertisement
Table of Contents
