4.3
Electrical Specifications
4.3.1
Power Mode
The Integra M2106+ Wireless CPU
Working modes
OFF mode
FAST idle mode
SLOW idle mode
FAST Standby mode
SLOW Standby mode
Communication
mode
The power consumption depends on the configuration used. It is for this reason that the following power
consumption values are given for each modes, RF bands and software used (AT or Open AT
All the following information is given, by assuming a 50 Ω RF output.
5.0 VDC power supply value is used to measure the consumption.
For more information on power consumption measurement, hardware configuration, SIM used, and software
Dhrystone application, see the AT command Interface Guide documentation [7].
©Confidential
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without prior written
agreement.
WA_DEV_M2106+_PTS_003-001
®
supports different power consumption modes:
®
The Wireless CPU
is in OFF mode.
®
The Wireless CPU
is synchronized with an RF GSM/GPRS network.
The internal 26 MHz of the Wireless CPU
®
The Wireless CPU
is synchronized with an RF GSM/GPRS tester.
The internal 26 MHz of the Wireless CPU
The SIM and Radio interface are deactivated via AT command or Open AT API:
-The embedded application is running
-The serial port remains active (AT commands are available).
The internal 26 MHz of the Wireless CPU
This mode is similar to the FAST Standby mode.
All the features are disabled (no GSM, no GPRS, no SIM and no Serial port).
The internal 26 MHz of the Wireless CPU
A GSM/GPRS communication is established with a RF GSM/GPRS network.
Erreur ! Style non défini.
Comments
®
is constantly active.
®
is not constantly active.
®
is constantly active.
®
is not constantly active.
Integra M2106+
®
).
Page: 50 / 77
April, 2007