Example Of At Commands; This Document Is The Sole And Exclusive Property Of Wavecom. Not To Be Distributed Or Divulged Without Prior Written; Agreement - Wavecom Integra M2106+ Product Specification

6.5.3

Example of AT Commands

This section gives examples to get started with AT commands. Refer to the AT commands Interface Guide
documentation [7] for details.
6.5.3.1 Example of AT commands for Quick Starting the Wireless CPU
The table below lists the main AT commands required to start the Wireless CPU
Description
Enter PIN Code
®
Wireless CPU
synchronization
checking
Receiving an
incoming call
Initiate a call
(Don't forget the «;»
Initiate an
(Don't forget the «;»
emergency call
Communication loss
Hang up
Store the
parameters in
EEPROM
©Confidential

This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without prior written

agreement.

WA_DEV_M2106+_PTS_003-001
Wireless CPU
AT commands
+CME ERROR: 16
AT+CPIN=1234
+CME ERROR: 3
CREG= <mode>,1
CREG= <mode>,2
AT+CREG?
CREG= <mode>,0
ATA
ATD<phone
number>;
+CME ERROR: 11
at the end for
+CME ERROR: 3
« voice » call)
ATD112;
at the end for
« voice » call)
NO CARRIER
ATH
AT&W
Using the Integra Wireless CPU
®
®
's
response
OK
Wireless CPU
Wireless CPU
on the network, no synchronization
OK
OK Communication established.
PIN code not entered (with +CMEE=
AOC credit exceeded or the
communication is already
OK Communication established.
OK
The configuration settings are stored
OK
Integra M2106+
®
.
Comment
PIN Code accepted.
Incorrect PIN Code
(with +CMEE= 1 mode).
PIN already entered
(with +CMEE= 1 mode).
®
synchronized on
the network.
Synchronization lost, re-
synchronization attempt.
®
not synchronized
attempt.
Answer the call.
1 mode).
established.
in EEPROM.
Page: 65 / 77
April, 2007
®