Setting The Rs-232 Dip Switch (S2) - AMX PT10-PRV 2 X 1 Instruction Manual

Troubleshooting

Setting the RS-232 DIP Switch (S2)

If you are experiencing communication problems with the AXB-EM232, check the
communications settings for the device. The RS-232 communication parameters for this device are
set via the eight-position RS-232 DIP switch. On the AXB-EM232, the RS-232 DIP switch is
located on the front panel. Verify that this DIP switch is set to the default positions indicated in
below.
The following describes the RS-232 DIP switch default positions:
The following table lists the RS-232 DIP switch settings:
RS-232 DIP Switch (S2) Settings
Position
Function Stop Bits Data Bits
6
• 9,600 baud
• No parity
• 8 bits
• 1 stop bit
1 2 3
Parity
Off Off Off
2 bits 7 bits Unused
On On On
1 bit 8 bits Unused
Off
Unused
On
Unused
Off
Unused
On
Even
Off
On
None
4 5 6 7
Baud Rate
Off Off Off Off
300
Off Off On Off
600
On Off Off On
1,200
On Off On On
2,400
Off On Off Off
4,800
Off On On Off
9,600
On On Off On
Odd 19,200
On On On On
38,400
PT10-PRV 2 X 1 Preview Switcher System
8
Off
Off
Off
Off
On
On
On
On