American Dynamics SpeedDome Optima LT Specifications page 5

SpeedDome Ultra 8
A note About the Dome ASSembly:
A dome assembly is comprised of two
individual components:
1. Camera Module
2. I/O Board
Mounting Base
We offer an I/O Board
Mounting Base which
makes installation as easy as
screwing in a lightbulb with
just three simple steps:
1) Connect the composite
cables for power, communication
and video to the I/O PC board
in the mounting base.
2) Secure the mounting base to
the ceiling or desired location.
3 & 4) Connect the housing
and eyeball assembly to the
base by aligning the cap and
base tabs, and then turning
the housing clockwise until you
hear a click. Once the housing
is secured, only the florescent
dot will be seen.
5) Dome is mounted and
ready-to-go. Wait a few
seconds for dome to begin
its homing routine. This
mounting base supports four
alarm inputs and three alarm
outputs.
Product offerings and specifications are subject to change without notice. Actual products may vary
from photos. Not all products include all features. Availability varies by region; contact your sales rep.
2
1. each comPoNeNt iNDiviDuaLLy
camera module, mounting base, mount, housing and bubble.
or
2. a PRe-coNfiguReD Dome Kit, which includes the
following components:
b
c
d
e
1
c Mounts
2
1)
3
d Housings
4
e
Bubbles
5
* Indoor use only.
o R D e R i N g o P t i o N s
C amera Module (Color with Day/Night mode)
I /O Board Mounting Base (if applicable)
M ounts
1) Hard Ceiling, 2) 2'x2' Drop Ceiling or 3) Long Wall
H ousings
1) Top hat housing for indoor applications
2) Environmental housing for outdoor applications
B ubbles (smoked or clear)
Camera Module b
2) 2' x 2' Drop Ceiling
(Indoor)
Hard Ceiling (Indoor)
3) Long Wall (Outdoor)
2) Indoor & Outdoor
1) Top Hat (Indoor)
Smoked Silver
Gold *
I/O Board Mounting Base
*
Clear
23
—
24