Use this setting if you want a specific area to be under surveillance after an operator stops moving the dome. For SpeedDome Optima LT, the home position is established by programming Pattern 3 with Focus Near or Focus Far as the first command. This indicates to the dome that pattern 3 should be used as the home position.
Supported Controllers and Matrix Switching Systems SpeedDome Optima LT may be used with the following controllers and matrix switching systems. See notes below for specific limitations or restrictions. ADTT16E VM32 / AD32 VM96 Series Series Series Feature SensorNet SensorNet SensorNet...
Define Pattern #2 Define Pattern #3 End Pattern Definition Accept (save) New Pattern Go to Pattern #1 17 Call Shot SPEEDDOME OPTIMA LT PROGRAMMABLE DOME CAMERA QUICK REFERENCE GUIDE Dome Function Go to Pattern #2 Go to Pattern #3 Run Pattern #1...
Page 6
Clear Pattern #2 Clear Pattern #3 Enter V-phase Adjustment 67 Shot, followed by iris Exit V-phase Adjustment SPEEDDOME OPTIMA LT PROGRAMMABLE DOME CAMERA QUICK REFERENCE GUIDE MegaPower 48 Matrix Switcher/ Controller System See Supported AD Keyboards on page 5 for button names used on specific keyboards.
Page 7
• Set Auxiliary 4 OFF (70-F1) • Set Auxiliary 4 ON (71-F1) SPEEDDOME OPTIMA LT PROGRAMMABLE DOME CAMERA QUICK REFERENCE GUIDE Manchester Commands These commands are supported by systems using the Manchester protocol. See Supported AD Keyboards on page 5 for button names used on specific keyboards.
See “SpeedDome Optima LT Features” on page 2. Other Declarations Thank you for using American Dynamics products. We support our products through an extensive and worldwide network of dealers. The dealer, through whom you originally purchased this product, is your point of contact if you have a need for service or support.