American Dynamics ADSDUPIHC Installation Manual
Indoor housing and indoor vandal resistant housing
Hide thumbs
Also See for ADSDUPIHC:
- Specification (2 pages) ,
- Specifications (2 pages) ,
- Specifications (24 pages)
Advertisement
SpeedDome
®
Ultra Indoor
Housing and Indoor Vandal-
Resistant Housing
Installation Guide
Models: ADSDUPIHC. ADSDUPIHS,
ADSDUPVRC, ADSDUPVRS
For Indoor Use Only!
Figure 1. SpeedDome Ultra housings
Indoor Housing
About this Guide
This guide explains how to prepare the indoor
housing for installation to a mounting structure and
assumes that the mounting structure is in place
and that data and power cables have been pulled
to the installation site.
This guide does not explain:
- Cable requirements,
- Camera installation, or
- How to install the mounting structure.
For this information, see instructions shipped with
the camera dome or mounting structure.
About the Indoor Housing
The indoor housing (Figure 1) is used to attach the
SpeedDome Ultra camera dome to an indoor
mounting structure. This housing can attach to
mounting structures shown in Table 1.
© 2005 Sensormatic Electronics Corp.
SPEEDDOME ULTRA INDOOR HOUSING AND INDOOR VANDAL-RESISTANT HOUSING
INSTALLATION GUIDE
Indoor Vandal-
Resistant Housing
1 of 4
Table 1. Indoor mounting Structures
RHOPN
Pendant Mount
RHIUIBM
I-Beam Mount
RHOSW/RHOLW
Short/Long
Wall Mount
RHOWCA
Corner Mount
RHOWPA
Pole Mount
ROENDC
End Cap
If You Need Assistance...
Contact your sales representative.
8200-0184-07, REV. B
Advertisement
Table of Contents
Related Manuals for American Dynamics ADSDUPIHC
Summary of Contents for American Dynamics ADSDUPIHC
- Page 1 SpeedDome ® Ultra Indoor Housing and Indoor Vandal- Resistant Housing Installation Guide Models: ADSDUPIHC. ADSDUPIHS, ADSDUPVRC, ADSDUPVRS For Indoor Use Only! Figure 1. SpeedDome Ultra housings Indoor Housing Resistant Housing About this Guide This guide explains how to prepare the indoor...
- Page 2 Warnings and Cautions Please review the following warnings and cautions before you begin installation or service. WARNINGS WARNING! ALWAYS USE: • Proper safety equipment for the location and type of installation. • Proper lift equipment to reach the installation. • Safety features of the lift equipment.
- Page 3 Installation WARNING: Ensure that ac power and electrical signals are off before beginning this procedure. 1. See instructions supplied with the SpeedDome Ultra housing and eyeball assembly for how to prepare it for installation in the housing. 2. Connect the housing and eyeball assembly to the base (Figure 2) by aligning the Cap and Base tabs and then turning clockwise until you hear a click.
- Page 4 Parts List Only parts below can be ordered, and only by authorized users. To become authorized, contact your sales representative. Note: Not all of the parts are orderable. Parts are subject to change based on design improvements and availability. Table 2. Parts list Bubble/Trim Assy.
Need help?
Do you have a question about the ADSDUPIHC and is the answer not in the manual?
Questions and answers