Table of Contents
Advertisement
4. OmniTouch Fax Server installation procedure
IMPORTANT: Ensure that you have completed all of the pre-installation steps found in
Chapter 3 before continuing with the installation steps below! Failure to do so will result
in a non-functional OmniTouch Fax Server installation.
4.1.
Installation
Assuming the OmniTouch Fax server installation CD-ROM has been mounted to
/media/cdrom, run the following command as user root:
# rpm -Uhv /media/cdrom/server/OmniTouchFaxServer-5.6.0-xxx.i386.rpm
(Where, xxx, represents the build version of the OmniTouch Fax Server software.)
4.2.
Configuration
After installing the application, for interactive configuration run the following command:
# /opt/ofs/scripts/setup.sh
IMPORTANT: The OmniTouch Fax Server setup process will change the MySQL root
password to 'faxserver'.
Note: The setup process prompts for a language for initial cover sheets and notification
profiles. These can be modified later using the administration tool.
Then, to configure OmniTouch Fax Server for first use, run the following command:
# /opt/ofs/scripts/firsttimesetup.sh
All the changes made by this command can be modified later using the administration
tool.
Then, to configure Tomcat and Apache for use with OmniTouch Fax Server, run the
following command:
# /opt/ofs/scripts/setup_tomcat.sh
4.3.
Running in console mode
Once the configuration is complete, the OmniTouch Fax Server services will be launched
automatically using the daemon scripts located in /etc/init.d. You may, however,
choose to run any service in console mode. To do so, perform the following:
1) If necessary stop the currently running service by running:
# /etc/init.d/<service_name> status (to see if the service is currently running)
# /etc/init.d/<service_name> stop
Alcatel-Lucent Applications
8AL_90214_USAA ed.01
Page 10
Advertisement
Table of Contents
