Do not restart the BSC until instructed to do so at the end of this procedure.
6.
Step 5: Restart Services on the Master and All Nodes
To restart each BSC, click the click here link in the Restart message on the Replication
Master, on all of the Replication Nodes, and on any combination Master/Node BSC if
using cascaded replication. When the services restart, all setup information in the
Replication Master snapshot is automatically uploaded to the Replication Nodes.
Configuring a Replication Override
To configure a replication override, log into each BSC in your Secure Mobility MatriX via
the administrator console and complete the following steps:
1.
Click the Mobility MatriX tab in the BSC administrator console, click the Replication
Setup tab on the Mobility MatriX page, and then click the Node Override link at the
top of the page. The Replicated Data Override page appears as shown in Figure 14-
15.
BlueSecure™ Controller Setup and Administration Guide
Figure 14-14: Configuring a Replication Master/Node
Figure 14-15: BSC Replicated Data Override Page
Replication
14-15